Network requirements

KNX Studio reaches the KNX bus through a KNXnet/IP tunnelling interface on your IP network. This article describes what that connection needs, so you can set up the network or find out why an interface doesn’t show up.

Finding interfaces automatically

To find interfaces, KNX Studio sends a search request by IP multicast to 224.0.23.12, UDP port 3671. Each KNXnet/IP interface that receives it answers, and appears under Discovered in the  Bus Interface menu.

This works when your Mac or iPad and the interface are in the same network, and the network forwards multicast between them. It usually doesn’t work across routers, through a VPN, or on guest and public Wi-Fi networks that isolate devices from each other.

Connecting to an interface

KNX Studio connects to the interface’s IP address on port 3671, unless you enter a different port when you add the interface manually. Choose UDP or TCP as the IP protocol. UDP works with every KNXnet/IP interface; choose TCP only if the interface supports it.

If KNX Studio can’t find an interface, for example because it’s in a different network or behind a NAT router, add it manually with its IP address and port. See Connect to the KNX bus.

Interfaces that require secure tunnelling can’t be used yet. KNX Studio marks them in the list.

Allowing access to the local network

The first time KNX Studio looks for interfaces, your Mac or iPad asks whether it may find and connect to devices on your local network. Allow it, or KNX Studio can’t find or reach interfaces on the local network.

If you didn’t allow access, turn it on later in System Settings on Mac, or in Settings on iPad: go to Privacy & Security > Local Network, and turn on KNX Studio.

Troubleshooting

If an interface doesn’t appear or isn’t reachable, check these points in order:

  1. Make sure KNX Studio has access to the local network.
  2. Make sure your Mac or iPad is in the same network as the interface, and not on a guest network.
  3. Add the interface manually, and click Test Connection to see whether KNX Studio can reach it.

If it still doesn’t work, report the problem from inside the app.