Plan a Project
Planning describes the building and its KNX system before anything is programmed. KNX Studio looks at a project from two sides, and you can switch between them at any time:
- The building shows the floors and rooms, and the functions in them, such as lights and blinds.
- The topology shows how devices are connected to the KNX bus, in areas and lines, and gives each device its physical address.
Group addresses tie the two together: they let a push button in one room switch an actuator in the distribution board.
A good order is to start with what should happen and end with how the devices do it:
- Structure the building into floors and rooms.
- Add functions to the rooms, such as a ceiling light or a blind. With automatic management, KNX Studio creates their group addresses.
- Set up the topology, so devices have a line to go on.
- Add devices to lines and rooms, and set their parameters.
- Link group addresses to communication objects so devices work together. If you need more group addresses than KNX Studio created, create them yourself.
You don’t have to stick to this order. You can go back to any step later, for example to add a room or another device.
When your plan is ready, continue with Commission Devices.