Control functions

With KNX Studio, you control the functions in your rooms and see their current state. Lights, blinds, outlets, and door locks can be switched; sensors only report their values. Instead of walking to the push button in the living room, you switch the ceiling light from KNX Studio and see right away whether the switch actuator responds.

A function controls the devices that are linked to its group addresses. If you haven’t done so yet, link the group addresses and program the devices first.

Turn on Live Mode

Functions can be controlled only while Live Mode is on. Click  Bus Interface in the toolbar and turn on Live Mode. Until you do, function symbols are gray and controls are disabled. To learn more, see Connect to the KNX bus.

Find a function

In  Home, the functions are sorted into the categories Lighting, Climate, Energy, and Security. Each category shows its functions as tiles, grouped by room. In the family house, the ceiling light is in Lighting, and the blind is in Climate, both under Living Room.

While Live Mode is on, each tile shows the function’s current state, for example whether the ceiling light is on. When someone presses the push button in the living room, the tile changes too.

Switch a function

Click the symbol on a tile to switch the function. Clicking the light bulb  turns the ceiling light on or off, and clicking the blind symbol  moves the blind up or down. The same works for outlets and door locks.

Use all controls of a function

For more than on and off, click the tile itself. Its details open, and Control lists everything the function can do. For a dimmable light, you set the brightness with Dimming. For the blind, use Move to open, close, or stop it, or set an exact Position. Colored lights offer controls for their color. Each control uses the properties of the function, so the blind offers Position only if it has Target Position and Current Position.

Below Control, Properties shows the current values of everything else the function reports, such as the readings of a temperature sensor.

The state comes from the devices. If a function doesn’t show its state, check that the device is linked to the group address that reports it, for example the one that reports whether the ceiling light is on.

If a device doesn’t do what you expect, check its links and parameters, and program it again. If you think KNX Studio is at fault, report the problem.