Program devices

Programming is where your plan reaches the real devices. KNX Studio loads two things into each device: its physical address, so it can be reached on the bus, and its application program, which contains the parameters and links you set up.

Before you start, connect to the KNX bus.

During the beta, you can’t program couplers, KNX RF devices, or devices configured for KNX Secure. For couplers, you can load only the physical address.

Program a device

In the family house, start with the switch actuator in the distribution board, then program the push button in the living room.

  1. In Building, right-click the device (on iPad, touch and hold it), then choose Program.
  2. Choose what to load. For a new device, choose Physical Address & Application Program. If the device already has its address and you only changed parameters or links, choose Application Program.
  3. When KNX Studio asks for it, press the programming button on the device. That’s how KNX Studio knows which physical device you mean, so make sure you’re standing at the right one.

Programming takes a moment. You can follow its progress, and see when it’s done, in Activities in the sidebar. When both devices are programmed, press the push button: the ceiling light should turn on.

Unload or restart a device

Unloading removes the application program from a device, for example before you reuse it in another project. Restarting helps when a device doesn’t behave as expected. Right-click the device (on iPad, touch and hold it) and choose Unload or Restart.

To check your work, turn on Live Mode and switch the light from KNX Studio. If something doesn’t work, report the problem.